read?file=durabak+application+instructions << (Read Online)

where to buy durabak

durabak removal

metcote etch primer

durabak metal etch primer

spraying durabak

durabak smooth vs textured

can you paint over durabak

durabak 18 smooth

24 Sep 2015
5 Jun 2012
adhesion of Duram Durabak first. • Cement: Allow new cement at least 28 days to cure. Old and new cement or concrete surfaces must be acid-etched, rinsed well and dried. Prime with Duram Duraprime epoxy primer as per instructions if damp or oil contaminated. APPLICATION. Spray-on: Screw spray gun onto can, and
To apply DURABAK to an old epoxy surface, do a small test for adhesion: clean surface, rinse with water, and let dry. roughen surface with 40-grit sandpaper. wipe with xylene on a rag to remove any residue left from cleaning. apply 1st coat of DURABAK and let dry. apply 2nd coat of DURABAK and let dry for 2 days.
Follow our application instructions for easy step by step instructions on how to apply Durabak. Call us today at 888.613.4501.
Application Tip Sheet. SURFACE PREPARATION. Surface preparation and application instructions for both DURABAK - M26TM and. DURABAK 18 - M26TM is identical unless otherwise noted. IMPORTANT – READ CAREFULLY! DURABAK - M26TM will bond well to properly prepared, clean, thoroughly dry surfaces. On.
Before applying Durabak, always do a small test for adhesion: clean surface, rinse with water, and let dry. roughen surface with 40-grit sandpaper. wipe with Xylene, Aromatic 100 (ARO 100) or Oxsol 100 on a rag to remove any residue left from cleaning. apply 1st coat of Durabak and let dry.

PAINT AND VARNISH. Remove all peeling, cracking or chipping paint. Clean surface thoroughly. For best results, lightly abrade surface with an 80-grit sandpaper. Clean the surface with a good cleaner, such as tri-sodium phosphate (TSP). It is strongly recommended to wipe surface with Xylene before applying DURABAK™.
If the new concrete contains plasticizers, a small test for adhesion is essential using a primer such as COTE-L's METCOTE™. • If the concrete is oil-soaked, then see instructions for oil-soaked concrete (see below). Old concrete should: • Be completely dry before application of DURABAK™. • Be shotblasted, if possible, and

Annons

The photo has no tags

March 2018