November
May 2010
Mitt hår är kort igen. Och rött. Och lockigt. Och jag cosplayade Mad Hatter på Uppcon. ...loggade in på bdb och hade tre nya PMs. Men kunde inte läsa dem. FÖR ATT BDB TAGIT BORT DOM EFTERSOM D
So like. For the interested parties. This is my current hair. Only, it's red. o/ (I find it quite easier to write in English. I don't know. I type faster.)
Tyckte jag fångade ett ganska snyggt ansiktsuttryck på min katt. Eller vad säger ni? |Db
So. I said red. And this is what I meant~ Ursäkta de suddiga fläckarna. Märkte inte först att spegeln inte var riktigt ren :(
~
Mullet~
Camwhoringgggg
Mehhh
:|a
Hmmmm
Obligatory weird face. And that's all. Aaah haven't camwhored in forever.
Om du läser detta, även om vi inte talas vid så ofta, så kommentera med ett minne om dig&mig ett bra eller dåligt; vad som helst!
Nu är ni utmanade! Ladda upp en bild som gör er glad!
Make a hat in two hours. Okay guys. Today I'm going to make a hat, using a piece of cardboard, scissors, tape and some cloth. Also superglue and sewing needle and thread. Bara copypastat från min L
Cut out a strip of the cardboard and roll it together. This will be the base of the hat.
By the way, meet my hat model, Miki :3 He's a Fairyland Tiny Fairy. An MSD Ball Jointed Doll.
Put the hat-base to another piece of cardboard and draw a circle around it that's slightly bigger. This will be the top.
Cut that piece out and glue/tape it to one side of the base. (preferably glue). It should look like this.
Get a piece of cloth, any cloth, just not stretchy cloth, glue it to the edge of the top, and stretch it to the bottom, around, inside the base. Be sure that the cloth isn't too thick. That'll just bu
Cut another piece of cloth as big and round as the top and glue it on on the top. Cut off any excess.
Draw a circle as big as the base of the hat on a new piece of cloth, and cut a small circle out of it on the inside. Be sure to leave some excess there. This will be the brim of the hat.
Take a piece of wire and make a circle larger than the one you drew. Tape it together.
Make cuts out to the edges of your drawn circle, so you get flaps to glue on.
Be sure to have excess space outside the range of your wire-circle so you can fold it over the wire later.
Turn the hat upside down and glue the circle to the insides of it, using the flaps to fasten it in the glue. Like this.
Visa toppen
Show footer