read?file=pinion+depth+tool+instructions << (Read Online)

setting pinion depth without tool

proform pinion depth tool instructions

ratech pinion depth tool

best pinion depth tool

pinion depth tool harbor freight

pinion depth tool rental

how to measure pinion depth

yukon pinion depth tool

6) continued. On top of the pinion, place the correct target plate. This is a precisely calibrated smooth plate to take measurements from. If you are starting from scratch, you won't have any idea which shims to install under the bearing, so install none. This means you will have to pull the bearing at least one more time. Even.
A Jegs Universal Pinion Depth Setting Tool may used to measure the exact pinion depth of automotive differential components. A Jegs pinion depth tool is similar in design to pinion depth measuring tools produced by other manufacturers, and is used in the same fashion. Measurements are taken by attaching the tool to
Jul 12, 2015
Chevy truck 12-b0lt AMX' Rambler,. 3.9 & higher 4.575" Javelin 4500'“. 3.7 & lower 4.565". Pinion Depths for. Dana Rear Axles. 9,, 4375" Ford Dana 27 2.094". 8" 4000 Dana 40 2.625". 8-bolt Pinto 3.450" Dana 53 2500". 8-8" 4420,, Dana 70 3.500". 7.5" 4.040". Universal Pinion. Depth Setting Tool. Instruction
Aug 5, 2016
Jan 2, 2017
Subtract PHT from MHD for pinion depth (PD). 2) Calibrate the tool according to the instruction manual. Write down that number (calibrated depth). 3) Set up the tool (dial indicator) inside the housing and take your indicator reading, then subtract that number from the calibrated depth.
Place the pinion setting tool on top of the pinion head with the slot end of the tool in the carrier bearing journal. (fig. 3,4,5) The end of the tool will rest against the end of axle tube surface. Take the measurement from the dial caliper and subtract it from the dimension printed on the tool.
PRODUCTS. INSTRUCTIONS FOR THE T&D DELUXE PlNlON DEPTH CHECKER KIT. INTRODUCTION. The T&D Pinion Depth Checker Kit is a very accurate method of setting pinion depth in a large number of automotive differentials. Though it may work on others, this kit is equipped to set-up the following differentials.
Move the dial indicator so it contacts the pinion head approximately 1" from the first measurement point. Measure the pinion depth at this new point. If the two pinion depth measurements are not identical, shim the tool to square it with the pinion and remeasure until both readings are the same. 6.

Annons

The photo has no tags

February 2018