read?file=sikkens+cetol+1+application+guide << (Read Online)

sikkens cetol 1 colors

cetol 23 maintenance

cetol maintenance

cetol maintenance coat

how to apply sikkens cetol door and window

sikkens cetol 23 plus dealers

how to apply sikkens cetol marine

cetol application tips

Hi folks; I am wondering what the basics are that I need to know in applying the Sikkens cetol finish to the outside of a cabin I am building. Do I need to brush it on?Can I use a power sprayer? Never used one of them but spending a week or so with a brush in my hand is a little daunting. Any advice would be
Page 1. ® I & CETOL. ® 23 PLUS. APPLICATION GUIDE. Working With. Cetol. ® I & Cetol. ® 23 Plus. ¦ Preparation Procedures. Vertical Surfaces: New, Weathered, Uncoated Wood. The best method to prepare vertical wood surfaces is to sand with 80-120 grit sandpaper. However, an alternative to sanding for preparation is
Let the surface dry for 48 hours before applying the coating. 5. If there are any glossy patches, scuff sand with 80 grit sandpaper. 6. Cetol SRD should be applied within one week of preparation for horizontal surfaces (decks) and within four weeks on vertical surfaces (siding). Tips. • Refer to Sikkens Hardwoods Care
Clean a spot with a 3 to 1 solution of bleach and water to remove all mold and mildew. Rinse and allow the wood to dry thoroughly. Apply a thin coat of Sikkens Cetol 23 to the cleaned area, and observe if the patch turns dark. If it does, the wall must be stripped of all the old stain per Sikkens instructions, either with sanding
When using the, Cetol 1 & Cetol 23 Plus, old coatings must be completely removed before application. COATING 1. Use a wax-free chemical stripper, following the manufacturer's instructions, to strip down to bare wood. 2. Let the surface dry for three (3) good dry days before beginning to coat the wood. The wood must be
Before application of a maintenance coat, prepare the surface using the previously mentioned TSP solution, but reduce the solution to 2 ounces of 100% powdered Tri-Sodium Phosphate or phosphate-free substitute. Let the surface dry for 3 days after power washing. Apply 1 coat of Cetol 23 Plus.
1-2 week period. If a high gloss finish is desired, Cetol Marine Gloss can be applied after the initial application of three coats of Cetol Marine, Marine Light or Cetol Marine Natural Teak. Cetol Marine with Interlux All-Purpose Boat Soap, as per instructions on label, then sand the surface lightly with 220-320 grit sandpaper.
1-866-745-5367. • Please refer to the stripping chemical manufacturer's product label, for safety and detailed application instructions. Exterior Preparation Procedures – Chemical Stripping . Sikkens ProLuxe Cetol SRD Semi-Transparent Stain is a one-coat, exterior wood stain for use on a variety of wood surfaces.
After preparation, apply one even coat of Cetol 1 RE Wood Finish, avoiding heavy application. Allow to dry a minimum of 24 hours. Must be top coated with two coats of Cetol® 23 Plus RE Top Coat, The first coat must be thoroughly dry before application of the second coat.
Please refer to the Product Label, TDS or SDS safety and detailed application instructions.. Cetol® BL Interior. Sikkens Technical Datasheets Download. Cetol® UV Interior. Sikkens Technical Datasheets Download. Cetol® Door & Window. Sikkens Technical Datasheets Download. Cetol® 1 RE™. Sikkens Technical

Annons

The photo has no tags

March 2018