Friday 6 April 2018 photo 5/15
![]() ![]() ![]() |
Cc debugger user guide: >> http://nzu.cloudz.pw/download?file=cc+debugger+user+guide << (Download)
Cc debugger user guide: >> http://nzu.cloudz.pw/read?file=cc+debugger+user+guide << (Read Online)
26 Jun 2014 CC Debugger User's Guide ok - CC Debugger User's Guide SWRU197F SWRU197F June 2013 Table of C
CSn. Chip Select (active low). DC. Debug Clock. DD. Debug Data. DUT. Device Under Test. GND. Ground. LED. Light Emitting Diode. MISO. Master In Slave Out. MOSI. Master Out Slave In. RF. Radio Frequency. SCLK. Serial Clock. SoC. System on Chip. SPI. Serial Peripheral Interface. USB. Universal Serial Bus. Vdd.
CSn. Chip Select (active low). DC. Debug Clock. DD. Debug Data. DUT. Device Under Test. GND. Ground. LED. Light Emitting Diode. MISO. Master In Slave Out. MOSI. Master Out Slave In. RF. Radio Frequency. SCLK. Serial Clock. SoC. System on Chip. SPI. Serial Peripheral Interface. USB. Universal Serial Bus. Vdd.
Contents. CC Debugger, Mini USB cable, 10 pin flat cable with 2x5 2.54mm connector, 10 pin flat cable with 2x5 1.27mm connector, Converter board 2.54mm-1.27mm connector, Documentation
CC Debugger w kategorii ZigBee / Wireless -- CC Debugger debugger oraz programator dla SOC z serii CCxxxx opartych na rdzeniu 8051 produkowanych przez Texas Instruments. Programator jest zgodny z oryginalnym TI Package Contains. CC Debugger ? 1; USB cable ? 1; 10-pin flat cable ? 1; User Guide CD ? 1
CC-DEBUGGER - программатор/отладчик для малопотребляющих РЧ СнК (система на кристалле). RF System-on-Chips; Core Architecture:8051; Core Sub-Architecture:80C51; IC Product Type:Debugger / Programmer; Kit Contents:CC Debugger, Mini USB Cable, 10-Pin Flat Cable, Converter Board, Documentation
Regulated voltage on CC Debugger: 3.3 Volt. Maximum target current draw (*): 200 mA (*). Supported Operating Systems: Microsoft® Windows® 2000. Windows XP SP2/SP3 (32 bit versions). Windows Vista® (32 & 64 bit). Windows 7 (32 & 64 bit). References. - CC-Debugger Quick Start Guide www.ti.com/lit/swru196.
CC Debugger. The CC Debugger can be used as interface to program SoC's mounted on Battery Boards and to update the USB MCU on. SmartRF05EB. CLI. Command Line Interface. Factory firmware. The firmware that is supplied programmed into the USB MCU from the factory. This firmware supports SmartRF® Studio.
User's Guide. SWRU197H–September 2010–Revised April 2014. CC Debugger. 1. Introduction. The CC Debugger is primarily used for Flash programming and debugging software running on CCxxxx. 8051-based System-on-Chip (SoC) devices from Texas Instruments. The PC tools available for these purposes are the
STEP 6 – Start Using the Tool. The CC Debugger can be used to flash a TI Low Power RF System on Chip using. SmartRF Flash Programmer, control the device using SmartRF Studio or for debugging using IAR Embedded Workbench. For additional information, please refer to the CC Debugger User's Guide (swru197).
Annons