Rectangular groove using a shaper Cutting of Gear Teeth using. Milling Machine. PART –C.
Sl.No. Name of the Experiment. Page No. 1 STEP & TAPER TURNING. 2. 2 THREAD CUTTING. 4. 3 KNURLING & ECCENTRIC TURNING. 7. 4 V-GROOVE ANGLE. 9. 5 SPUR GEAR MILLING. 11. 6 DUMBELL. 16. 7 HANDLE. 18. 8 CONNECTING ROD. 20. 9 LAP JOINT. 22. 10 SQUARE BUTT JOINT. 23. 11 T-JOINT. 25.
To generate the eccentric contour, the X axis requires a stroke motion. This stroke motion is obtained from the contour of the thread and must be synchronized with the spindle. The stroke motion is generated using a master value coupling. The stroke motion is superimposed on the motion of the real feed axis X via a
Man always put his efforts to save his energy and the time required to do his work. At the same he is also worried about the quality of the products he produced and cost of the product. It is felt that during eccentric turning quite a good amount of time is spent in setting up the job in a four jaw chuck. Moreover even for a skilled
An eccentric shaft may have two or more diameters and several different center axes. The amount of eccentricity, or half of the throw, is the linear distance that a set of center holes has been offset from the normal center axis of the workpiece. Eccentric turning on the lathe is used for the following eccentric turning situations:.
rkm2003. Turning Operations. ?Machine Tool – LATHE. ?Job (workpiece) – rotary motion. ?Tool – linear motions. ?“Mother of Machine Tools “. ?Cylindrical and flat surfaces . rkm2003. Eccentric Turning. Axis of job. Axis. Eccentric peg. (to be turned). 4-jaw chuck. Cutting speed. O p e ra tio n. s o n. La th e.
ABSTRACT. Man always put his efforts to save his energy and the time required to do his work. At the same he is also worried about the quality of the products he produced and cost of the product. It is felt that during eccentric turning quite a good amount of time is spent in setting up the job in a four jaw chuck. Moreover

Annons

The photo has no tags

December 2024