read?file=pertronix+flame+thrower+coil+instructions << (Read Online)

INSTALLATION. INSTRUCTIONS. NOTE: REMOVE OR BYPASS EXTERNAL BALLAST RESISTOR OR. RESISTANCE WIRE WHEN INSTALLING THE RECOMMENDED. FLAME-THROWER COIL, UNLESS THE PRIMARY RESISTANCE. IS LOWER THAN SPECIFIED. WE RECOMMEND A PERTRONIX FLAME-THROWER
Flame-Thrower III coils are only compatible with Ignitor III ignition systems, and most Capacitive Discharge (CD) systems that control the dwell period, or limit the current. (12volt negative ground systems). HIGH PERFORMANCE COIL. INSTALLATION INSTRUCTIONS. * Legal in all 50 states and Canada. CARB E. O. #D-57-
The Ignitor II differs from the Ignitor in that it's a "smart" ignition system, able to sense current levels of power in the ignition coil and adjust the dwell as you drive. We're talking more than four times the available energy from the coil than in a point-triggered distributor! When you add the Pertronix Flame-Thrower II coil, ignition
CARB E. O. #D-57-10. HIGH PERFORMANCE COIL. INSTALLATION INSTRUCTIONS. * Legal in all 50 states and Canada. CARB E. O. #D-57-10. FLAME-THROWER II COIL APPLICATIONS. Use with: System. Voltage. Cylinders. Primary. Resistance. Recommended Flame-Thrower II. Coils. Black. Chrome. Epoxy. Ignitor II.
Flamethrower high performance coil. Many vehicles came equipped with ballast resistor or resistance wire. To achieve optimum performance from the Ignitor ignition system, we recommend the removal of these components. • To remove a ballast resistor, (normally white ceramic blocks 3 to 4 inches long), disconnect all
of the coil. HIGH. PERFORMANCE. COIL. INSTALLATION. INSTRUCTIONS. NOTE: ALWAYS REMOVE EXTERNAL BALLAST RESISTOR OR. RESISTANCE WIRE WHEN INSTALLING A FLAME-THROWER. III COIL. WE RECOMMEND A PERTRONIX FLAME-THROWER III COIL SHOULD. ALWAYS BE INSTALLED BY A
Turn the ignition switch off and disconnect the battery negative cable. 2. Remove the coil high tension wire from the coil tower. 3. Label and remove all wires from the positive and negative coil terminals. 4. Remove the existing coil. 5. The Flame-Thrower HC coil can be mounted in a variety of positions and locations. Choose
One of the more frequent problems discussed on the Healey Email list involves the installation of after market items intended to enhance the performance of our cars. Frequently these exchanges involve the installation of solid state ignition systems. The following exchange on the Healey List involved this writer and was.
25 Jul 2014
INSTALLATION INSTRUCTIONS. * Legal in all 50 states FLAME-THROWER COIL APPLICATIONS. Use with: System. Voltage. Cylinders. Primary. Resistance. Recommended Flamethrower. Coils. Black Chrome. Epoxy PerTronix, Inc. warrants to the original Purchaser of its Flame-Thrower coils that the product shall be

Annons

March 2018