January
Monday 4 December 2017 photo 4/15
|
Fluorescent lamp holder installation instructions: >> http://igc.cloudz.pw/download?file=fluorescent+lamp+holder+installation+instructions << (Download)
Fluorescent lamp holder installation instructions: >> http://igc.cloudz.pw/read?file=fluorescent+lamp+holder+installation+instructions << (Read Online)
philips advance ballast wiring diagrams
t8 led tube light installation guide
wiring non shunted tombstones
t8 led tube wiring diagram
t8 led tube light circuit diagram
non shunted tombstones lowes
shunted lamp holder home depot
non shunted lamp holder lowes
Check the existing wiring for damage before installing upgrade kit. Do not install if existing wires are damaged. WARNING– To avoid potential fire or shock hazard, do not use this retrofit kit in luminaires employing shunted bi-pin lamp holders. Note: Shunted lamp holders are found only in fluorescent luminaires with Instant-
7 Dec 2015
INSTALLATION INSTRUCTIONS. Linear FLuorescent strip Lights. FSBX. Rev. 10/10/2013. IMPORTANT: • Read all instructions carefully before attempting installation. If you do not understand these instructions, please consult your local distributor. • Thoroughly inspect the fixture for any freight damage; freight damage
Apply the "Live End" sticker properly within the fixture to indicate where power is supplied. (3).Do not apply uncertified LED driver with the Safety Precautions:. Direct Wire /Line voltage. Wiring Instruction-Electronic Ballast retrofit luminaire with 1 lamp. AC120-277V. L. N. Fluorescent lamp. Electronic. Ballast. AC120-277V.
Risk of fire/electric shock – the electrical rating of this product is 120V. Installer must determine whether they have 120V at the fixture before installation. Risk of fire/electric shock – T8 LED tube installation requires knowledge of fluorescent lighting luminaires and electrical systems. If not qualified, DO NOT attempt installation
INSTRUCTIONS: 1. Switch off power supply before re-wiring and installation. 2. Remove the conventional fluorescent tube. 3. Remove the electronic ballast. 4. Rewire the fixture as shown in the AFTER. RETROFIT circuit diagram and connect the included starter holder to the cord of anode in series. 5. Install the T8 LED
3) WARNING—To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects. 4) WARNING: To avoid potential fire or shock hazard, do not use this retrofit kit in Iuminaires employing shunted bi-pin lamp holders. Note: Shunted lamp holders are found only in fluorescent
Instructions. • Philips LED T8 System with Optifuse Technology are suitable to replace either. T8 fluorescent lamps in fixtures containing standard non-shunted G13. (medium bi-pin) sockets. During retrofit, rewiring is a MUST, please follow the installation steps on the back page. Lamps Ordering, Electrical and Technical
CAUTION: For your safety and proper operation of this fixture, read instructions carefully before you start. Note and -Turn off the power supply at the fuse or circuit breaker box before you install the fixture. -Turn off the power supply again when you FLUORESCENT STRIP LIGHT. Medium Bipin Lamps ( Sold Separately ).
HFA2 Series. Fluorescent Highbay. INSTALLATION INSTRUCTIONS. IMPORTANT: Read all instructions carefully before attempting installation. If you do not understand these instructions, please consult your local distributor. Thoroughly inspect the fixture for any freight damage; freight damage should be reported to.
Annons
Visa toppen
Show footer