January
Monday 4 December 2017 photo 7/15
|
Cj2a body mount instructions: >> http://rir.cloudz.pw/download?file=cj2a+body+mount+instructions << (Download)
Cj2a body mount instructions: >> http://rir.cloudz.pw/read?file=cj2a+body+mount+instructions << (Read Online)
wwii jeep parts
jeep cj5 body mount locations
cj5 body mount diagram
cj3a body mounts
kaiser willys
cj2a body mounts
willys jeep body mounts
willys wagon body parts
If you encounter any problems during the installation of your Convertible Top, or at any later date, please contact your authorized. Bestop dealer or call our . The mounts may need to be loosened later to adjust the Vertical Retainer position. Rear point of measurement on body. 66 1/2" CJ2A, CJ3A, CJ3B. 65 1/2" MB (WWII).
I finally figured out why my windshield hits the hood when I fold it down - the PO used 1/8" rubber pads for body mounts. The tub meets the fenders about an inch lower than normal. So I need to elevate the body relative to the fenders. How thick should the body bushings be? Are they all the same thickness?
I touched on it but one must have a correct and straight frame or more work will be required to make any body fit. I will be My Jeep is an early 46 CJ2A. I know its not It is critical that the steering column lines up with the dash mount, and remember the brake and clutch pedals have a upright support between them. In short
May 26, 2013 Jeep CJ3A CJ5 CJ2A CJ3B replacement Body Mount Bushings Kit made by Daystar. Lifetime Warranty. Ships Immediately. Part Number KJ04001BK.
This mounting kit comes with a combination of 1/2" and 3/4" round pads and stainless steel hardware to properly mount the body tub to the frame. Fits: 41-45 MB Questions: There was no mounting hardware and the bolts were mixed on my CJ2A 1949 when I took the tub off the frame. Is there a . This is a replacement kit.
Aug 29, 2016
Willys Jeep Parts & Willys Restoration Parts from Walck's 4 Wheel Drive. FREE SHIPPING on wiring harnesses, CJ2a, CJ5, Willys Truck & other Willys Jeep Parts.
Place one round (10.45mm ID) washer onto frame then place one 3/4" body mount on washer. Repeat this step for all mounting points. Check the body with level from the bottom up - adjust as needed.
Oct 3, 2009
Annons
Visa toppen
Show footer