Horizontal Right. Condensing, Direct Vent. Gas-Fired Furnace. XR 90. TUX040,060,080,100,120C. TDX040 Furnace Trane GUNE-SVX001A-EN Installation, Operation And Maintenance Manual. Tubular indoor
1. Use only with the type of gas approved for this furnace. Refer to the furnace rating plate. 2. Install this furnace only in a location and position as instructions. 3. .. 90. They should be sized in accordance with ACCA Manual D or whichever is applicable. Central furnaces, when used in connection with cooling units, shall be
Natural Gas and Propane Installation Code and these instructions. Determine that there is no blockage or restriction, leakage, corrosion and other deficiencies .. 90. They should be sized in accordance with ACCA Manual D. Central Furnaces, when used in connection with cooling units, shall be installed in parallel or on
tions, as specified in “Gas Piping" (pages 31-32), of these instructions. 6. Always install the furnace to operate within the furnace's intended temperature-rise .. 90. They should be sized in accordance with ACCA Manual D or which- ever is applicable. Central furnaces, when used in connection with cooling units, shall be
ATTENTION, INSTALLER! After installing the furnace, show the user how to turn off gas and electricity to the furnace. Point out control and switch locations for turning off gas and electricity. Go over the User's. Information Manual and Section 23, “Maintaining Furnace. In Good Working Order" in this manual with the user.
Refer to the furnace rating plate. 2. Install this furnace only in a location and position of these instructions. 10. This product must be gas piped by a Licensed. 3. Provide adequate combustion 2015 Trane All Rights Reserved. 18-CD19D5-32-EN . der a horizontally installed evaporator coil or 90% gas furnace. Connect the
(C) 2015 Trane All Rights Reserved g. Clean the furnace, duct work, and components upon substantial completion of the construction process, and verify furnace operating conditions including ignition, input rate, temperature rise and venting, according to the manufacturer's in- structions. 10. This product must be gas piped
6 Nov 2011
tion manual. The installation must comply with regulations of the serv- ing gas supplier, local building, heating, plumbing, and other codes. In absence of local .. Support. Angle (x3). Maintain 6" minimum clearance between support rods and front of furnace. LEFT SIDE VENT. RIGHT SIDE VENT. Rotate vent blower 90°.
11 Nov 2016 Furnace casing and terminating outside the space containing the Furnace. 8. A gas-fired Furnace for installation in a residential garage must be installed as specified in "Location and Clearances" section of these instructions. 9. The furnace may be used for temporary heating of buildings or structures under

Annons

The photo has no tags

March 2018