2" socket (with 2" Spigot O.D.) in saddle sizes 2" through 6" to fit IPS pipe using a built-in O-ring seal. Internal cutter is operated using
15 Mar 2000 Make STOPPLE Plugger Hot-tap. Install tapping machine on TDW Sandwich Valve and tighten flange bolts evenly. Fitting and al joints below valve must be tested before starting tap. Test pressure to be determined by customer. Connect hydraulic hoses from power unit to tapping machine for air line from air
sales take-off points, tie-over points, and as part of a stopple application. This section is intended to provide guidance on the safety, job planning, site preparation, installation and testing of hot tap connections that involve a welded connection of a branch to a mainline pipeline, and reinforced by means of a full-encirclement
1 Aug 2014
Installation Instructions of Microclustered Water Generator Cartridge. Water80 ionized microcluster alkaline water inline filter can not be installed alone as Push the stopple stick firmly into the hose until it can not be pushed further. 3. Take a hose to connect. Microclustered Alkaline Water. Cartridge. Insert the hose through
27 Mar 2010
30 Aug 2015
29 Aug 2014 To establish a clear set of guidelines to be followed when performing Hot Tap and Stopple installations. 2. DEFINITIONS. Coupon – The part of the pipe that is removed during the Hot Tap operation. Hot Tap – The method of making a mechanical tie-in by welding an attachment to the pipe that is in service
For more than 60 years, the TDW STOPPLE® plugging machine has represented one of the safest and most reliable solutions for isolating pressurized sections of The plug is then lowered into position through LOCK-O-RING flanges, the tapping machine is removed, valves are recovered, and blind flanges are installed.
30 Aug 2015

Annons

The photo has no tags

February 2018