Gen 1 VVT controls manual. This is for the original CDS system with the governor thermostats. Any - Answered by a verified HVAC Technician.
Installation, Service, and. Troubleshooting Instructions. CONTENTS .. Carrier rooftop units. Refer to the Apollo control installation instructions for information on the placement of the factory- installed Apollo control in the rooftop unit. Wiring Connections. WIRE RELAY .. VVT® Monitor Thermostat. 2. Bypass Controller. 3.
GENERAL. The 3V control system VVT bypass controller (33ZCBC-01) is a system static pressure controller the bypass controller through a Carrier network user interface such as the System Pilot or Carrier software. facturer's instructions to avoid injury to personnel or dam- age to equipment and property. Disconnect all
Test before attaching to damper actuator. Call the local Carrier representative if more informa- tion is needed about wiring the VVT System or the zone controller. Damper Circuit Board Installation — The damper circuit board is located in the damper module. Refer to the damper installation instructions for more information
View and Download Carrier COMFORT SYSTEM 33CS operating manual online. Comfort VVT System, Monitor Thermostat With Timeclock, Zone Controller. CARRIER COMFORT SYSTEM 33CS Thermostat pdf manual download.
This manual provides detailed explanations of the opera- tion of the Carrier Comfort System bypass controller and each configurable function. The configurable functions al- low the operation of the bypass controller to be adjusted to match specific user needs and system requirements. The bypass controller is the pressure
A. T2. (OPN-VVTZC). B. T. 485. NOTE This document gives instructions for field-installation of a VVT Zone Controller in an i-Vu Open Control. System. However, VVT Zone Controllers are available factory-mounted to Carrier's round and rectangular dampers. Damper assemblies have an integrated duct temperature sensor.
related to the Carrier communication bus. NOTE: For complete details on the configuration of all af- fected options, refer to the Monitor Thermostat Application manual. GENERAL OPERATING PROBLEMS. N0 Display — If the monitor thermostat display remains blank after 24 VAC power has been applied to the damper.
Carrier 3V, VVT control system, for parallel flow units only. All control arrangements include a standard linear inlet flow sensor, control enclosure, SCR fan speed controller, 24-volt transformer and fan relay. The 3V, VVT terminals are not available on series terminal units. The 3V, VVT packages must be used in conjunction
screens for the System Pilot, VVT zone controller, and Bypass. Controller are shown in Fig. 1-3. OAT Display — The System Pilot has an outside air tem- perature (OAT) software point that can be forced from the. Carrier communicating network. If the System Pilot is display- ing any default screen and the EXIT and SELECT

Annons

The photo has no tags

March 2018