Thursday 1 March 2018 photo 8/11

$Cisco route map configuration guide: >> http://icp.cloudz.pw/download?file=cisco+route+map+configuration+guide << (Download) Cisco route map configuration guide: >> http://icp.cloudz.pw/read?file=cisco+route+map+configuration+guide << (Read Online) policy based routing cisco policy based routing configuration example route map set interface route map cisco bgp route-map permit 10 cisco route map logic cisco route map example route map cisco tutorial Cisco ASA 5500 Series Configuration Guide using the CLI. 23. Defining Route Maps. This chapter describes route maps and includes the following sections: • Information About Route Maps, page 23-1. • Licensing Requirements for Route Maps, page 23-3. • Guidelines and Limitations, page 23-3. • Defining a Route Map, If the route-map keyword is used without the vrf keyword, recursive static routes defined by the route map will be applicable for the global VRF or topology. SUMMARY STEPS. 1. enable. 2. configure terminal. 3. vrf definition vrf-name. 4. rd route- route-map name {permit | deny} [sequence_number] Example: hostname(config)# route-map name {permit} [12]. Creates the route map entry. Enters route-map configuration mode. Route map entries are read in order. You can identify the order using 26 Nov 2003 Using Figure 2-1 as a guide, Example 2-12 lists the route table of the clanton router followed by the route map configuration used to match the OSPF routes with a metric of 20. This example redistributes OSPF routes into EIGRP routes that have a metric of 20. 23 Mar 2010 This chapter helps you prepare for the CCNP ROUTE exam by covering the following topics related to implementing path control: Offset lists, Cisco IOS IP Service Level Agreements, and Policy routing using route maps. Configuring Policy-Based Routing. Policy-Based Routing Configuration Task List. QC-44. Cisco IOS Quality of Service Solutions Configuration Guide. To enable PBR on an interface, use the following commands beginning in global configuration mode: Command. Purpose. Step 1. Router(config)# route-map map-tag [permit Software Configuration Guide—Release 12.2(25)SG. OL-7659- This chapter describes the tasks for configuring policy-based routing (PBR) on a router and includes as route maps. The route maps used by PBR dictate the policy, determining to where the packets are forwarded. Route maps are composed of statements. 25 Jan 2018 To enable policy-based routing on an interface, indicate which route map the device should use by using the ip policy route-map map-tag command in interface configuration mode. A packet arriving on the specified interface is subject to policy-based routing except when its destination IP address is the One or more match commands and one or more set commands typically follow a route-map global configuration command. If there are no match commands, then everything matches. If there are no set commands, nothing is done (other than the match). Therefore, you need 17 Jun 2009 Step.3::Configure match commands. PBR allows the user to match packets based on the length and characteristics of a packet, using a standard or extended ACL. To define the matching criteria based on the policy, issue these commands from route map configuration mode: match le$