4".
ROBERTSHAW CONTROLS. 720 Series Pilot Ignition Gas Valves. The 720 Series Valves (7200 IPER) are designed for intermittent pilot ignition applications. The 720 IPER Series Valve incorporates a manual valve, pilot valve, dual automatic valves (2), and a main gas pressure regulator. Uni-Kits are factory-set at the 3.5"
The control includes a manual valve, two automatic operators, a pressure regulator, . 36E36-304, 36E22-214. 720-079 (7200IPER), 720-080 . Robert-Shaw. TWO IMPERFECT. THREADS. GAS CONTROL. THREAD PIPE THE AMOUNT. SHOWN IN TABLE FOR. INSERTION INTO GAS CONTROL. APPLY A MODERATE
Read these installation and operating instructions carefully before you install or attempt to use this Direct. Vent Counterflow Wall Furnace. .. STANDING PILOT I.I.D. PILOT. Pilot Adj. Screw. Pilot Adj. Screw. ROBERTSHAW. 7200ER-SO4. ROBERTSHAW. 7200IPER-SO4. FIGURE 7C. FIGURE 7D. STANDING PILOT I.I.D.
out one could ruin the Robert Shaw. Unitrol unit. (Blow out the bellows). 1. Hold red reset button down longer. It May have to replace Robert Shaw UNITROL unit. 1. Remove burner and orifice. 2. Clean with compressed air. Figure 3. Troubleshooting Pilot Flame. 1. CORRECT FLAME. 2. NOISY, LIFTING, BLOWING 3.
Do not follow the original lighting procedures on this furnace or attempt to use a match to relight the pilot or main burner. This furnace is equipped with a Robertshaw® Intermittent. Pilot Ignition System. This system is designed to eliminate the need for a constant burning pilot. Lighting of the pilot is accomplished through
Millivolt – Wall thermostat actuated with manual gas cock, automatic pilot safety valve and a Millivolt operator. The automatic pilot safety is separate from gas cock and provides shutoff in case of pilot outage. Millivolt gas valves do not require external power source. ? Voltage – 12 Volts DC, 24 Volt, 120 Volt, and 240 Volt –.
Results 1 - 73 of 73 The Robertshaw® 700 Series Universal Gas Valves are designed for intermittent pilot ignition applications. These universal models include all the necessary parts to adapt the valves to direct spark or hot surface applications. Each valve incorporates a manual valve, pilot valve, and a main gas pressure
The Robertshaw® 720 Series Gas Controls are designed for a wide variety of heaOng applicaOons and can be incorporaOng a manual valve, safety shutoff magnet, dual automaOc valves (hence the term “dual valves"), Wiring connecOons, manual selector and adjustments are easily accessible on the top of the valve.

Annons

The photo has no tags

March 2018