January
Sunday 4 March 2018 photo 9/15
|
Curlin pump instructions: >> http://dcu.cloudz.pw/download?file=curlin+pump+instructions << (Download)
Curlin pump instructions: >> http://dcu.cloudz.pw/read?file=curlin+pump+instructions << (Read Online)
curlin pump training video
curlin pump error codes
curlin pump tubing
curlin pump patient guide
curlin pump tpn
moog curlin pump
curlin pump 6000 error codes
curlin pump replace set 4
Refer to the User Manual for MedLMTS instructions. 9. At Next? Press YES to continue. NOTE: Bag Volume should include overfill volume if pump priming and/or a KVO is programmed. 10. Enter Bag Volume, press YES. NOTE: To force an auto-calculation, enter any 2 of the 3 entries: Amt TBI, RATE or TIME, the unknown
Your physician has prescribed the Curlin Medical ambulatory infusion pump to assist in delivering your medical treatment. Your healthcare clinician will program the pump specifically for your therapy and teach you how to use the 3 Follow your clinician's instructions for inserting the bag spike into the IV bag so that it is not.
Equalize the pressure in the set by priming if instructed to do so by your clinician (disconnect from your IV site). Turn pump OFF then ON to reset the sensor prior to resuming the infusion. Check placement of the administration set and close pump door properly. Turn pump off by pressing the OFF key.
6 Jun 2012
CURLIN™ 6000 Ambulatory Infusion Pump Training Videos. Our comprehensive training videos offer step-by- step instructions in 35 chapters – from loading the set and pump priming to alarms and programming therapies. An excellent resource for troubleshooting or training review. Watch Videos
Note: Throughout this Manual the text will refer to the Moog Curlin Infusion pump. All the features described here apply equally to the 6000 Plus™ and the 6000 CMS™ pumps, unless specifically otherwise stated. et's begin by introducing you to the Moog Curlin Infusion pump, an easy-to-use, ambulatory or pole mounted
19 May 2013
Curlin IV Pump. Wash Hands: With soap and water for at least 15 seconds (sing Happy Birthday) and dry with paper towels. Installing Batteries: 1. Locate battery door on back of pump. 2. Insert coin into door notch, pushing down on release pin; slide door open in downward motion. 3. Install two “C" batteries into pump and
Press the Run/Pause button to begin the infusion. you turn the pump off. If you are in the middle of infusing a bag, follow these directions carefully. turn the pump off Without pausing the infusion ?rst.
Use antibacterial soap and water, rubbing your hands for 20 seconds. Remove any dirt from under your nails. Dry your hands with a paper towel or clean hand towel. If no soap and water is available, use an alcohol-based hand sanitizer. 4. Gather your supplies: a. Medication bag b. IV tubing c. Curlin pump d. 2 C batteries.
Annons
Visa toppen
Show footer