read?file=dek+tite+installation+instructions << (Read Online)

Dektite Retrofit Original. Metal Roof Flashings. When it's not possible to slide a flashing over the top of a pipe or vent, you need a Dektite® Retrofit™. Great for repairs on existing installations. Available in black and grey EPDM or Red Silicone. EPDM will withstand constant temperatures at the roofline of -50 C to 115 C and
installation instructions. Trim Dektite® cone to suit pipe size using sharp tin snips. After lubricating the flue with water, slide Dektite® Aluminium™ down to the tile level. Place upper edge of base under tiles, forming an anti-capillary fold. Cut tabs and then just press and tab the bottom corners to form a soaker run-off tray.
Dektite®. Original. Installation Instructions. 1. Cut Dektite at appropriate pipe diameter marking. 2. Slide Dektite flashing down over pipe. 3. Apply sealant on underside of flexible aluminum base. 4. Press Dektite base into contours of panel configuration. 5. Fasten Dektite to surface with long-life, self drilling fasteners.
INSTALLATION INSTRUCTIONS. DEKTITE MULTICABLE SOLAR FLASHINGS. Fit the acrylic lead apron in the same way as a conventional lead weathering slate. The area where the tiles or slates have been cut or moved should be completely covered. It will normally be inserted under the tiles or slates above the
12 Dec 2011
Dektite Installation Guidelines. Applications. Plumbing, Heating, Air Conditioning, Electrical and Exhaust Vents. Notes: • Dekite can be installed over or between the ribs of standard panels. • DO NOT install over SSR or architectural panel ribs. • Generally no sealant is required where the Dektitecollar provides a compression
installation instructions. Seldek® installation instructions. Cut Dektite® cone where indicated for the relevant pipe size. Fasten flashing to surface with self-tapping or self drilling screws; or selected pop rivets. Use a Dektite® on the. 'diamond' or bias for enlarged holes and penetrations on steep pitched roofs or deep
Installation Instructions: Cut a neat hole in roofing sheet with minimum clearance for pipe and insert pipe through hole. Trim the cone to suit pipe size using sharp tin snips. Where required, support cut sections of sheet with additional framing. Slide Dektite flashing down over pipe. Lubricating the pipe with water allows the.
Trim the cone of the Dektite flashing to suit the flue pipe using sharp tin snips. Using water as a lubricant slide the roof flashing down the flue pipe. If the flue pipe has a folded seam then once the flashing is fully installed apply a bead of silicone where this seam meets the EPDM cone to make sure that it is waterproof. Ensure
The essential way to flash and seal pipe penetrations through most roof sheet profiles. Download The Complete Handbook · Where to Purchase Products. Click a product from the range below to download a PDF brochure with detailed installation instructions

Annons

The photo has no tags

March 2018