4" x 5". Ideal for fastening wood, steel or other products to concrete.
ALUMINUM DUAL RATED SPLIT BOLT. CONNECTORS APS SERIES. WARNING REQUIREMENTS. INSTALLATION INSTRUCTIONS. 1. STRIP INSULATION FROM WIRE MAKE SURE DURING INSTALLATION THAT THE COPPER CONDUCTOR IS UNDER THE ALUMI-. NUM CONDUCTOR AND SEPARATED BY
Securely anchor the outdoor unit down with bolts and a metal frame. Provide a suitable air baffle. In a Snowy Area (for Heat Pump-type Systems). Install the outdoor unit on a raised platform that is higher than drifting snow. Provide snow vents. When Connecting Refrigerant Tubing. ‡ Ventilate the room well, in the event
What is the proper way to insulate split bolt connectors. to the correct length and insert into the Polaris. Tighten to the proper torque, install the caps and you are done. The reason I asked in the first place was not because I don't know how to read instructions supplied on new parts. (As if they come with
23 Jun 2014
14 Nov 2016 For connecting a single wire, place the wire below the spacer pad. For connecting two wires, place one above and below the spacer pad. 3. Torque the HandyBug™ nut to: SB232TC38: 275 in-lbs (23 ft-lbs) to securely fasten the wire(s) into the split bolt. SB252TC38: 385 in-lbs (32 ft-lbs) to securely fasten
Typical Cross Section of a. Compression Connector Before. Installation. Before compression, a typical cross section of cable consists of 75% metal and 25% air . Split Bolts. • Generally used as taps. • If conductors are different materials, a spacer bar is included. Aluminum conductor should always be positioned on top.
Hi, Is there a proper way (as determined by NEC, manufacturer or some other body)for split bolt connectors to be installed for LV applications (208V)? Should tape be used? What kind? I have heard that duct tape should not be used. I have also heard from other sources that no tape should be used. Thanks,
5 Oct 2010

Annons

The photo has no tags

February 2018