read?file=immersun+1+manual << (Read Online)

immersun bridge

immersun t1090

immersun best price

immersun t1060 price

immersun liquidation

immersun t1060

immersun 2 problems

immersun radio resets

Page 4: Overview. 1. Overview Thank you for choosing immerSUN. This intelligent device is a sensible and practical addition to your PV or Wind microgeneration system. Water is heated via your existing immersion heater, using surplus power that would otherwise have been exported to the grid.
One immerSUN can control up to 3 heaters sequentially. 0 Only one current sensor for ease of installation with the option of a wireless sensor. 0 Built-in 7-day programmable boost timer. 0 Manual boost function for both heater outputs. 0 Integral multi-function relay to provide additional functions such as: Economy-7.
Water heating for your PV systemInstallation and user guide 2 Contents 1 Overview 4 2 Technical Secification
1. In conjunction with the pv it appears to have a load of around 200 watts when both working this drops to zero when PV shuts down.- May be from PV rather than immersun but Initial results also indicate that my grid usage will drop by about 15% due to inaccuracies of previous semi manual operation.
12 Jul 2012 Contents. 1 Overview. 4. 2 Technical Specifications. 5. 3 Installation. 6. 3.1 Mounting. 6. 3.2 Electrical Connections. 7. 3.3 Clamp Installation. 8. 3.4 Wiring Diagrams. 9. 3.5 Using the immerSUN with a dual-rate electrical supply. 13. 4 Installer Settings. 14. 4.1 DIP Switch Settings. 14. 4.2 Installation Setup. 15.
One immerSUN can control up to 3 heaters sequentially. 0. Only one current sensor for ease of installation with the option of a wireless sensor. 0. Built-in 7-day programmable boost timer. 0. Manual boost function for both heater outputs. 0. Integral multi-function relay to provide additional functions such as: Economy-7.
12 Jul 2012 1. Overview. Thank you for choosing immerSUN. This intelligent device is a sensible and practical addition to your PV or Wind micro generation system. Water is heated via your existing immersion heater, using surplus power that would otherwise have been exported to the grid. Please read and follow this
27 Nov 2012 Referring to the instructions, you are able to carry out the following one time system calibration: 1. Turn On Heater. The unit is now looking to measure your immersion heater current. You need to ensure the thermostat is on, ideally run off a bucket load or more of hot water to ensure the immersion heater is
convenient place for future reference and observe all instructions contained therein. NOTE. It is recommended to install a 2-pole 16A magneto-thermal switch breaker between the AC cables coming from the mains and the AC cables going to the immersion heater. 1. Release the four screws of the device front cover and
One immerSUN can control two heaters sequentially. • Only one current sensor for ease of installation. • Built-in 7-day programmable boost timer. • Manual boost function for both heater outputs. • Integral multi-function relay to provide additional functions such as: Economy-7 control, cylinder de stratification pump.

Annons

The photo has no tags

March 2018