cylinder assembly and two-needles automatic mixture control carburetor. IMPORTANT. This engine will provide you with years of safe use, provided that you carefully follow these safety instructions: 1.
As I increase the throttle, just as it gets to the point when it goes light on the skids the engine seems to bog down and die. If I quickly up the It's a TT39 engine with the standard muffler, and I've probably put 2-3 tankfuls through it from new. Hope somebody can Read the instructions. Set the high speed
Content. 1. PRO-39H engine x 1 EA 2. Carburetor Assembly x 1 EA 3. Allen wrench x 3 EA (2.5mm &2mm &1.5mm) 4. Instructional manual x 1 EA 5. TT logo sticker x 1 EA
engine mounting screws are securely tightened. Installing the Muffler. The muffler must be mounted after the helicopter engine has been installed in the helicopter. Refer to the installation of the tank and engine in the helicopter manual for the proper sequence of installation steps. Important: Be sure the lock washers for the
The 30% will give you a little bit more power, however the engine will run a little warmer with your current (if the engine is tuned for flight) settings. Richen up a few clicks, i personally love Coolpower 30% High Performance Heli. kinda pricey but worth it. Concult your engine manual FIRST, it should have a
I purchased a TT39 pro engine or my heli. I have owned the engine for 37 days. It exploded on me while I was flying the heli two weeks ago. I have tried to send this engine to ACE hobby for repair. The engine was returned to me today saying the address was undeliverable. I took the address from the manual included with
Does anyone know where I can find this manual online. I have been googling it for a couple days now with no luck. I am trying to get my Raptor 30 started and I am having all kinds of trouble. I don't even know where the high and low needles are located and there is some other adjustment screw I have
Does anyone know if there is any electronic manuals online for the TT .39 heli engine? Basically I'm looking for baseline settings for the high and and specifically low end needle valve settings. The low end needle valve seems to be very vague in it's adjustment. I intend to pull the carb apart, clean it up, and

Annons

The photo has no tags

February 2018