Friday 2 March 2018 photo 41/44
|
Cc debugger user guide: >> http://raa.cloudz.pw/download?file=cc+debugger+user+guide << (Download)
Cc debugger user guide: >> http://raa.cloudz.pw/read?file=cc+debugger+user+guide << (Read Online)
cc debugger clone
cc debugger cc2541
smartrf flash programmer
cc debugger arduino
cc debugger schematic
cc debugger firmware
cc debugger cc2540
cc debugger quick start guide
The CC Debugger is primarily used for debugging and programming the flash on CCxxxx. 8051-based System-on-Chip (SoC) devices from Texas Instruments. The PC tools available for these purposes are the SmartRF™ Flash Programmer from Texas Instruments and IAR. Embedded Workbench® for 8051 from IAR
User's Guide. SWRU197H–September 2010–Revised April 2014. CC Debugger. 1. Introduction. The CC Debugger is primarily used for Flash programming and debugging software running on CCxxxx. 8051-based System-on-Chip (SoC) devices from Texas Instruments. The PC tools available for these purposes are the
5 May 2009 CSn. Chip Select (active low). DC. Debug Clock. DD. Debug Data. DUT. Device Under Test. GND. Ground. LED. Light Emitting Diode. MISO. Master In Slave Out. MOSI. Master Out Slave In. RF. Radio Frequency. SCLK. Serial Clock. SoC. System on Chip. SPI. Serial Peripheral Interface. USB. Universal
Contents in the box: CC Debugger; Mini USB cable; 10-pin flat cable with 2x5 2.54mm connector; 10-pin flat cable with 2x5 1.27mm connector; Converter board 2.54mm-1.27mm connector; Documentation. CC-Debugger can be used to program and debug the following 8051-based system-on-chips from Texas Instruments:.
Тип: Debugger and Programmer for RF System-on-Chips; Core Architecture:8051; Core Sub-Architecture:80C51; IC Product Type:Debugger / Programmer; Kit Contents:CC Debugger, Mini USB Cable, 10-Pin Flat Cable, Converter Board, Documentation
CSn. Chip Select (active low). DC. Debug Clock. DD. Debug Data. DUT. Device Under Test. GND. Ground. LED. Light Emitting Diode. MISO. Master In Slave Out. MOSI. Master Out Slave In. RF. Radio Frequency. SCLK. Serial Clock. SoC. System on Chip. SPI. Serial Peripheral Interface. USB. Universal Serial Bus. Vdd.
CC Debugger. The CC Debugger can be used as interface to program SoC's mounted on Battery Boards and to update the USB MCU on. SmartRF05EB. CLI. Command Line Interface. Factory firmware. The firmware that is supplied programmed into the USB MCU from the factory. This firmware supports SmartRF® Studio.
Contents. CC Debugger, Mini USB cable, 10 pin flat cable with 2x5 2.54mm connector, 10 pin flat cable with 2x5 1.27mm connector, Converter board 2.54mm-1.27mm connector, Documentation
Kit Includes. CC Debugger; Mini USB cable; 10-pin flat cable with 2x5 2.54mm connector; 10-pin flat cable with 2x5 1.27mm connector; Converter board 2.54mm-1.27mm connector; Documentation
to the PC. The User's Guide contains more information about the driver installation process. STEP 5 – Check Status LED. The LED on the CC Debugger will be turned on. If it is GREEN, the debugger has successfully detected the chip on the target. If it is RED, chip detection failed. Please make sure the debugger runs.
Annons