read?file=2811+hardware+installation+guide << (Read Online)

This document describes site requirements and equipment needed to install your Cisco 2800 series integrated services router. Warning Read the installation instructions before connecting the system to the power source. . Ground lug and two mounting screws (Cisco 2811, Cisco 2821, and Cisco 2851 routers only).
A Cisco 2811, Cisco 2821, or Cisco 2851 router with a DC-input power supply requires copper wire and crimp-type terminals for the power connections. . If your router uses the Cisco Redundant Power System (RPS), refer to the Cisco Redundant Power System Hardware Installation Guide for instructions about the power
Oct 31, 2013 This chapter contains the following sections: • Viewing the Cisco Network Module Installation Guide. • Installing Slot Dividers in Network Module Slots. • Installing and Removing Filler Panels in Network Module Slots. • Installing Blank Panels over Empty Chassis Slots. • Related Product Documentation
Oct 31, 2013 Cisco 2811, Cisco 2821, and Cisco 2851 routers can be equipped for operation using either AC or DC input power by installation of the appropriate to the applicable documentation for those products: the Cisco Network Modules Hardware Installation Guide or the Cisco Interface Cards Installation Guide.
Note The Cisco 2801 and Cisco 2811 routers do not support the 1000BASE-T Ethernet implementation. For more information on WAN interface cards, refer to the Cisco Interface Cards Installation Guide. For more information on network modules, refer to the Cisco Network Modules Hardware Installation Guide.
For detailed software configuration information, refer to the Cisco 2800 series software configuration documents and to the Cisco IOS configuration guides and command reference publications. These publications 2800 Series Routers. Describes hardware installation procedures that do not require opening the chassis.
Step 1 Guide the two halves of the slot divider between the two rails in the bottom of the HWIC slot. See Figure 4. Figure 4 Inserting Slot Divider into an HWIC Slot on Cisco 2811, Cisco 2821, and Cisco 2851 Routers. Step 2 Push the
Oct 31, 2013 Cisco 2800 Series Hardware Installation This document describes how to install or upgrade fans that are located internally within a Cisco 2811 series integrated services router. You need to remove Warning Read the installation instructions before connecting the system to the power source. Statement
Installing and Upgrading Fans in Cisco 2811 Series Routers · Cisco 2800 Series Hardware Documents: Introduction and Warnings · Overview of Cisco 2800 Notes. Cisco 2800 Series Hardware Installation Suggest ways Cisco technical documentation can be improved and better serve your needs. Participate in the
Oct 31, 2013 Cisco 2800 Series Hardware Installation Warning Read the installation instructions before connecting the system to the power source. . Cisco 2811, Cisco 2821, and Cisco 2851 routers have two DIMM connectors and are designed to operate with either one or two DRAM DIMMs installed, depending on

Annons

The photo has no tags

March 2018