read?file=cisco+ips+ssm+configuration+guide << (Read Online)

Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 5.1. OL-8677-01. 14. Configuring AIP-SSM. This chapter contains procedures that are specific to configuring AIP-SSM. It contains the following sections: • Configuration Sequence, page 14-1. • Verifying AIP-SSM Initialization, page 14-2. • Sending
This guide is a task-based configuration guide for the Cisco IPS 7.0 CLI. The term “sensor" is used throughout this guide to refer to all sensor models, unless a procedure refers to a specific appliance or to one of the modules, such as the AIM IPS, AIP SSM, IDSM2, or NME IPS. For an alphabetical list of all IPS commands,
Cisco Intrusion Prevention System CLI Configuration Guide for IPS 7.0. OL-18482-01. 18. Configuring the AIP SSM. Note. All IPS platforms allow ten concurrent CLI sessions. This chapter contains procedures that are specific to configuring the AIP SSM. It contains the following sections: • AIP SSM Configuration Sequence,
22-1. Cisco Security Appliance Command Line Configuration Guide. OL-10088-02. 22. Managing AIP SSM and CSC SSM. The Cisco ASA 5500 series adaptive security appliance supports a variety of SSMs. This chapter describes how to configure the adaptive security appliance to support an AIP SSM or a CSC SSM,.
31 Mar 2011 Americas Headquarters. Cisco Systems, Inc. 170 West Tasman Drive. San Jose, CA 95134-1706. USA www.cisco.com. Tel: 408 526-4000. 800 553-NETS (6387). Fax: 408 527-0883. Cisco Intrusion Prevention System CLI. Configuration Guide for IPS 7.1. Text Part Number: OL-19892-01
This section describes how to configure AIP-SSM to receive IPS traffic from ASA (inline or promiscuous mode), and contains the following sections: Note For more information on these commands, refer to Chapter 18, "Using Modular Policy Framework," in Cisco Security Appliance Command Line Configuration Guide.
Step 1 Log in to the adaptive security appliance. Step 2 Enter enable mode. asa# enable. Step 3 Configure the recovery settings for the AIP SSM. asa (enable)# hw-module module 1 recover configure
Cisco Intrusion Prevention System Appliance and Module Installation Guide for IPS 7.0 . If the AIP SSM is properly installed, the POWER indicator is solid green and the STATUS indicator is flashing green. You can also For the procedure for configuring the AIP SSM to receive IPS traffic, refer to Configuring the AIP SSM.
31 Oct 2013 Cisco Intrusion Prevention System Sensor CLI Configuration Guide for IPS 6.0 For the procedure for using the setup command to initialize the AIP SSM, see Initializing AIP SSM. If you have Cisco Adaptive Security Appliance Software 7.2.3 or later, configure up to four virtual sensors on the AIP SSM. 2.
Cisco Intrusion Prevention System CLI Sensor Configuration Guide for IPS 7.1. OL-19892-01. Chapter 18 Configuring the ASA 5500 AIP SSM. ASA 5500 AIP SSM Configuration Sequence. • IPS appliances reset both the attacker and victim when the Reset TCP Connection is selected and they reset the victim when Deny

Annons

The photo has no tags

March 2018