read?file=motorguide+xi5+calibration << (Read Online)

motorguide xi5 pinpoint problems

motorguide xi5 pinpoint gps manual

motorguide xi5 parts diagram

motorguide xi5 no gps signal

motorguide pinpoint gps gateway kit

motorguide xi5 software update

motorguide xi5 gps not working

motorguide pinpoint gps kit

There is a keel orientation calibration you have to do after install so when you hit jog it knows how your boat is sitting compared to the orientation of the I have my xi5 connected to my HDS via the gateway so when I want to anchor at a waypoint I tap the screen and then tap “anchor at waypoint" and it will
Alignment Calibration: press ( ) + 1,1,2. Audio Mode 1: press ( ) + 1,3,1. Audio Mode 2: press ( ) + 1,3,2. Audio Mode 3: press ( ) + 1,3,3. Refer to Owner's Manual for detailed instructions. Required Calibrations and Settings To ensure proper operation, it is necessary that the. Pinpoint Wireless Remote be synced to the
Called Motor Guide support. The guy told me to disconnect the negative side of the battery, disconnect the plug, wait a couple of minutes then hook the battery up and plug it in. He said that if that doesn't work take it to a lake and do a compass calibration. Give the hand held a command M +(1+1+1). Drive it
13 Apr 2017 COMPASS CALIBRATION IMPORTANT: This calibration is completed at the factory. It should only be repeated if the Pinpoint GPS system is not responding properly. This calibration must be done with the boat in the water, using the primary propulsion engine. IMPORTANT: A fixed GPS position is required
Installation, and Warranty manual included with your MotorGuide Xi5 trolling motor for can be found in the MotorGuide Xi5 Operation, Maintenance, Installation, calibration. The Pinpoint GPS system will emit an audible tune once it has acquired a fixed GPS position (in the default audio mode), and the GPS status.
Mounting Angle Calibration - MotorGuide Xi5 Pinpoint GPS.
23 May 2016 Having some issues with Xi5 anchor lock. When in Anchor Lock mode.it occasionally will go crazy spin around and make wild corrections(even in calm water). Almost knocked my friend out of the front of the boat the other day. :laugh: Is this a software issue?
a - Left turn b - Right turn c - Manual mode d - #2 button e - #1 button. IMPORTANT: A fixed GPS position is required to complete the mounting angle calibration. The Xi5 will emit an audible tune once it has acquired a fixed GPS position (in the default audio mode), and the GPS status indicator light will illuminate. a. 54153.
5 Dec 2013
21 Jan 2017 I loved my XI5 until 2 months ago it spun around an ripped the gps cable in to. Did you set forward angle and calibrate compass . happen for sure - my initial XI5 install in early 2015 went bad and had to have an board replaced - when I got unit back from an Approved Motorguide Repair Center, I tested

Annons

The photo has no tags

February 2018