January
Sunday 11 March 2018 photo 6/15
|
Hayes stroker ryde brakes manual: >> http://ksw.cloudz.pw/download?file=hayes+stroker+ryde+brakes+manual << (Download)
Hayes stroker ryde brakes manual: >> http://ksw.cloudz.pw/read?file=hayes+stroker+ryde+brakes+manual << (Read Online)
6 Jan 2010 Ryde brakes need the retaining pin refitting to a torque of 2Nm and the retaining clip snapping back into place. 15 Reset brake. Refit the mounting bolts to a torque of 12Nm. Pop the wheels back in the bike. Loosen the lateral adjustment bolts and give the brake lever a few good pumps. Once the brake has
First things first: the Hayes system uses DOT 3 or DOT 4 mechanical brake fluid. Second, the bleed starts from the caliper up to the brake lever. One important thing to note is that the reservoir on the handlebars (particularly in the Stroker and the El Camino models) are already at the highest point on the bike so there will
17 Sep 2015
Stroker Bleed Instructions. (Fig 1) Stroker Bleed Fittings. Air trapped in the hydraulic system of the disc brakes can decrease performance of the system and should be removed by “bleeding" the system and replenishing the system with new brake fluid. The system is filled by pumping fluid from the lowest point (at the caliper)
25 May 2008 I have fitted a set of Hayes Stroker Ryde brakes to my brother GT Avalanche 3 but the is alot of rubbing. I followed the instructions fully and but they say there should be a equal gap between the pads and the disc but the inner pad(nearest the spokes) is touching the disc and i cannot move the calipar any
the master cylinder and clamp at both clamp screws. Lever Reach Adjustment. Stroker Ryde : Adjust the brake lever reach by using a 2.5mm Allen wrench and turning the push rod that goes through the lever adjuster bushing. Do not attempt to force the adjustment screw beyond its limits. Stroker Trail/Carbon and Gram :.
This manual is intended to provide the information necessary for normal maintenance and service of the Hayes Disc Brake system. Although the steps and procedures are relatively simple, they should not be attempted until you are thoroughly familiar with the entire set of procedures. Photographs of actual hardware have
12 Oct 2009 Here's the scoop: Fork with 160mm IS adapator, front Hayes Stroker Trail This is my first set of hydro brakes. I followed Hayes instructions on.
22 May 2008
From your install manual, the "Burnish" period is only 30-40 stops, so you should be beyond that. If the bike is still within a month or two of purchase, I would suggest taking the bike back to the shop and playing dumb. They sold you the bike, they should fix the brakes that aren't working properly. If they say
Annons
Visa toppen
Show footer