Friday 29 December 2017 photo 10/14
|
2gig programming instructions: >> http://uvd.cloudz.pw/download?file=2gig+programming+instructions << (Download)
2gig programming instructions: >> http://uvd.cloudz.pw/read?file=2gig+programming+instructions << (Read Online)
2gig tech support
2gig go control factory reset
2gig quick programming guide
2gig change installer code
2gig gc3 installation manual
2gig go control installer code
2gig-cp21-345e installation manual
2gig troubleshooting
Quick Programming Guide. Control Panel Firmware Version 1.13. Download the Control Panel Installation Guide from dealer.2gig.com. GETTING STARTED. Q3 KEY FOB PROGRAMMING. To enter the control panel's System Con?guration module to program sensor zones and modify settings: If no key fob programming is
24 Mar 2015 In-depth Installation and Programming manual with everything you need to setup your 2GIG Go!Control Alarm Panel.
2GIG® GC3 Security & Automation System. Installation & Programming Guide. 10004669 RevA. WARNING: OWNER'S INSTRUCTION NOTICE. Not to be removed by anyone except occupant
View and Download 2gig Technologies 2GIG-CP2 installation & programming instructions online. Wireless Security System Go Control. 2GIG-CP2 Security System pdf manual download.
Download the GC2 Installafion & Programming Guide from dealer.2gig.com. Before programming the image sensor into a new network, you must reset it as follows: 1. Insert a paperclip into the hole on the front of the sensor to access the Reset button.
This forces the system to bypass all of the open sensors in the list, including any open interior sensors. 4 At the Enter Code screen, enter a valid user code to bypass the sensor. NOTE: The Quick Bypass feature can also be configured by the installer. For details, refer to the Control. Panel's Installation &. Programming Guide.
Programming. The following steps describe general guidelines for programming (learning) the sensor Panic Button Remote into the Control Panel. Scroll between opons using the < and > arrows. Move to the previous or next prompt by pressing the ^ and v arrows. 1. Select RF sensor # (01 to 48). Assign the Panic
and route the loop wire to the Control Panel's wall cutout. Use the log in the quick programming guide to document each sensor's ID number and location. 8. Install the optional remote sounder, and route the connection wire to the Control Panel's wall cutout. 9. Route the telephone line from the RJ31X jack to the Control.
Connect the battery and power up the system select: SECURITY, MENU, TOOLBOX, RIGHT ARROW,. INSTALLER TOOLBOX enter: 1561 select: Here is where you will be programing your different zones, or modifying the field programing. (see your Instalation/Programing Guide). System Configuration. Q.1 ZONE
8 Apr 2013
Annons